First, the vehicle configuration

The sweeper adopts Dongfeng Tianjin Type IV Chassis Conversion, and is equipped with auxiliary engines, fans, high pressure water pumps, clean water tanks, dustbins, left and right sweeps, wide suction nozzles with spray bars, low-pressure flushing systems, and garbage. Self-cleaning box, dust-removing system, hydraulic system, special device electronic control system and sub-frame, etc.:

1. Dongfeng Tianjin type IV class II chassis equipped with Cummins 180 (210) horsepower engine, luxury with sleeping cab, reversible, air brake , direction assist, low fuel consumption.

2. The auxiliary engine adopts Cono 140 (170) horsepower engine.

3, automatic clutch drive fan and high pressure water pump, reduce the impact of the engine on the start and stop the fan . The clutch has advantages of high wear resistance, long service life, low noise, low fuel consumption, and cost saving during use .

4, using Luoyang listed companies, Beibo Taixin high-power wear - resistant maintenance-free centrifugal fan, no noise, high efficiency and large amount of air , long service life .

5, the high-pressure pump using a plunger-type joint internationally renowned T7012IR column, suitable flow, high pressure, allowing the maximum pressure reached 1 6 MPa.

6. The clean water tank makes full use of the on-board space, with large capacity and a volume of 9 m3. It has a built-in water level alarm, and the water tank has internal anti-corrosion, anti-rust and anti-virus treatment to make the water pump run more safely and ensure the cleaning efficiency.

7. The trash can adopts the double-layer stainless steel inner structure, and the filter net plate is installed inside, which can effectively prevent the light and the like of leaves and plastic bags from blocking the outlet of the tuyere and dust. Built-in sewage alarm system, through the sewage valve at the rear door to facilitate the discharge of sewage to the sewer, maximize the use of the trash cans to fill the space. The car body is tilted and unloaded with a high pressure flushing device.

8. The self-cleaning device can help unload the trash when it is unloaded and clean the inside of the trash.

9, left and right to sweep a single sweep, reduce the number of sweeps and sweep brush consumption, can reduce the cost of use. A water spray device is installed on the brush to spray dust. Left and right sweeps separate the control, which can realize different operation modes such as right sweep and full sweep.

10. The width of the suction mouth of the wide suction nozzle reaches 20 00mm, ensuring that the total width of the operation is greater than 3 m. Four height-adjustable suction nozzle wheels can easily adjust and ensure a reasonable clearance between the suction nozzle and the road surface , so as to achieve a better suction effect and a higher suction efficiency .

11, the suction cup inner spray bar, the high pressure washing nozzles are arranged in the interior of the suction cup, the cleaning effect is not only good, but also to minimize the high pressure water stream from the red secondary dirt contamination generated. Right and left spray bar mounted on the suction cup, the suction cup down with simple and compact structure, fixed height from the ground to ensure that the spray bar, to achieve the best cleaning effect.

12. Adjustable spray-water spray rods at the rear of the carriage eliminate water pollution, eliminate secondary pollution and beautify the road surface .

13. The manual push - button hydraulic system of the cab drives the left and right vertical sweeping movements, left and right sweeping rib rotation, nozzle lifting and lowering, opening and closing of the rear door of the garbage can, dumping and dumping, and other mechanical actions.

14. The cycloid cycloid motor is imported from the United States Eaton, which has stable and reliable service life and low failure rate.

15. The hydraulic pipeline adopts German standard technology in the form of a sealed structure. It has good anti-vibration performance and high sealing reliability. It can achieve a leak-free sealing effect.

16. Huade hydraulic solenoid valve is used, and the key electronic control components are Siemens electrical switches, which have high reliability and long service life.

17, hydraulic components using integrated design, the electro-hydraulic centralized control of the cab, easy to operate.

18, install a manual pump emergency system, in the state of the auxiliary engine can also lift litter box, easy maintenance.

19. LED warning lights are used at the rear to ensure the safe operation of the vehicle.

20, non-stainless steel parts by electrophoretic rust treatment, durable.

21. The sub-frame bearing beam is welded with square steel with a section length of 160mm, width of 80mm and thickness of 10mm, which ensures the safety of the vehicle and makes the vehicle run more safely.

22, appearance design computer design, high side skirt, surface transition, the overall coordination of symmetry. Achieve low fuel consumption, low noise, streamlined design.

Second, the main technical parameters

1. The overall dimensions of the vehicle: length 8700 mm wide 2 500 mm high 2 95 0mm

2. Total mass of vehicle: 16000 Kg Rated load quality: 1900 Kg Cured mass: 13905 Kg

3. The maximum speed of this car can reach 1 1 5Km/h, sweeping speed: 3-25Km/h

4. Cleaning efficiency: ≥95%

5. The maximum suction particle size: 200mm

6. Maximum discharge angle of trash can: 45°

7. Maximum cleaning width: 3.2 m

8. Maximum cleaning capacity: 70000m2/h

9. Hydraulic tank capacity: 60L

10. Secondary engine working speed: 1700-2000 r/min

11. Overflow pressure: 16 MPa

12. Waste container volume: 7 m3

13. Water tank capacity: 9 m3

Third, chassis technical parameters

1. Chassis model: DFL1160BX5

2. Wheelbase: 5000 mm

3. Emission Standards: GB3847-2005, GB17691-2005 State IV

4. Tire specifications: 10.00-20,10.00R20,9.00-20,9.00R20,275/80R22.5 16PR

5. Number of tires: 6

6. Number of riders in the cab: 3 persons

7. Engine Model: ISB180 40 (ISB210 40) Power is 132 (155) Kw

 

http://WWW.HBCL99.COM

Sales Minister: Zhou Zhongxing

Sales Hotline: 15897596858 13329880698
Office Phone: 0722-3821899

Business Q Q : 165570129
E-mail:

Address of the company: Chengli Automobile Industrial Park in the southern suburbs of Suizhou City, Hubei Province

Research and development (R&D, R+D, or Rn'D)   research and technological development (RTD), refers to innovative activities undertaken by corporations or governments in developing new services or products, or improving existing services or products.  Research and development constitutes the first stage of development of a potential new service or product.

R&D activities differ from institution to institution, with two primary models  of an R&D department either staffed by engineers and tasked with directly developing new products, or staffed with industrial scientists and tasked with applied research in scientific or technological fields, which may facilitate future product development. R&D differs from the vast majority of corporate activities in that it is not intended to yield immediate profit, and generally carries greater risk and an uncertain return on investment. However R&D is crucial for acquiring larger shares of the market through the marketisation of new products.We convert ideas into products,such ideals for electronic or product design , from developing inventions for lone inventors and small business, to supporting large organisations with product design projects and manufacturing. Use our services as customer require to get  product made provide customer one stop service for final complete parts.

R&D Electronic Product Design

R&D Electronic Product Design,Customized Electronic Project Design,OEM Plastic Parts Customized Design,Custom Industrial Design

Topwell Spring Development Ltd. , http://www.topwelldesign.com