How to use biological safety cabinet
1. According to national standards and related regulations, explain to all users who may use biological safety cabinets the use of safety cabinets and restrictions. Staff should be given written instructions or safety manuals or operating manuals. In particular, the staff must be clearly informed that the safety cabinet cannot protect the operator in the event of spills, crushing, or improper methods. 2. The safety cabinet can only be used when it is working properly. 3. The glass observation window of the front face of the safety cabinet shall not be opened when the safety cabinet is in use. 4. The instruments and materials placed in the cabinet must be kept at a minimum. The air circulation at the rear of the plenum box must not be blocked. Before placing the material in the work area of ​​the cabinet, the surface should be decontaminated. 5. Bunsen burner (a kind of gas lamp) must not be used in the cabinet, because the heat generated by it may disturb the airflow and may damage the filter. A micro-electric incinerator can be used, but it is better to use a disposable sterilization ring. 6. All work in the cabinet is done in the middle or back of the work surface and can be seen from the observation panel. 7. The activity behind the operator should be minimal. 8. The operator should not extend the arm back and forth out of the cabinet to avoid disturbing the airflow. 9. The forward style grille must not be blocked by sticky notes, pipettes, or other materials. Doing so may interfere with airflow and may contaminate the material and expose personnel to the exposed state. 10. The surface of the cabinet should be cleaned with a suitable disinfectant after each work is completed and at the end of the day. 11. The fans of the cabinet must each run for 5 minutes before the work starts and after the work is completed. Biosafety cabinet placement The airflow from the opening in the front face of the biological safety cabinet into the cabinet is approximately 0.45 m/s. With this wind speed, the consistency of the unidirectional flow in the cabinet is easily disturbed, and it is easily disturbed by the movements of people near the safety cabinet, window openings, air distribution devices, and door switches. According to the ideal arrangement, it should be placed away from activities and may interfere with airflow. As much as 30 cm of space should be left behind and on both sides of the cabinet to facilitate maintenance. A height of 30 to 35 cm is left above the cabinet to accurately measure the wind speed of the exhaust filter and leave enough space for the replacement of the exhaust filter. Biological safety cabinet cleaning and disinfection All items in the biosafety cabinet, including the equipment, should be surface decontaminated and removed from the cabinet after the work is completed, as residual culture medium may provide microbial growth conditions. The inner surface of the safety cabinet should be decontaminated before and after each use. To disinfect the surface of the table and the inner wall with disinfectants, the disinfectant used should be able to kill any microorganisms that may be present in the cabinet. At the end of the day's work, a final surface decontamination treatment should be performed, ie a full wipe of the table, sides, back, and inside of the glass. Bleach fluids or 70% alcohol can be used as effective disinfectants for target organisms. If a bleaching agent is used as a corrosive disinfectant, a secondary wipe with sterile water is required. It is recommended that the work cabinet be in working condition during cleaning and disinfection. If it is not in working condition, it should be run for 5 minutes in order to clear the gas before the safety cabinet is closed. Biosafety cabinet decontamination For the decontamination of Class 1 and Class 2 biological safety cabinets, an appropriate amount of paraformaldehyde (the final concentration of paraformaldehyde in the air in the cabinet is 80%) is placed on an electric hotplate or frying pan (control from outside the cabinet) ). An electric plate or frying pan containing 10% more bicarbonate than paraformaldehyde was also placed inside the cabinet (control outside the cabinet). This second container should be covered with a lid that can be removed from a distance (for example, on a line that can be pulled from outside the cabinet). This can minimize prematurely neutralized paraformaldehyde. If the relative temperature is below 70%, there is an open container for hot water. If there is no front bulkhead, use a plastic type plastic baffle and stick it to the front face with tape to ensure that no gas leaks into the room. When the paraformaldehyde in the tray has completely evaporated or the switch has been turned on for 1 hour, the switch is turned off. Keep the safety cabinet for a full night without touching it. Then the cover of the second plate was removed and the switch turned on, and ammonia bicarbonate started to evaporate. At this time, turn off the switch on the plate, let the safety cabinet start working, and let the bicarbonate ammonia circulate for one hour. The front baffle (or plastic baffle) can then be removed and the safety cabinet can be used. Zhejiang Sujing Purification Equipment Co., Ltd. is located in Daoshui Town, Shangyu District, Shaoxing City, Zhejiang Province. It is an excellent manufacturer in the purification equipment industry in East China. Can provide professional air purification systems for industries such as microelectronics, biomedicine, hospital operating rooms, fiber optic cables, food and beverages, precision instruments, semiconductors, and new material applications in accordance with the ISO14644-1 standard, GB50073-2001 national standard, and national GMP specifications. Engineering design, construction, testing and technical services. Wood Pellet Packing Machine ton per bag wood Pellet Bagging Machine, which is specially used for packing the finished wood pellets into small bags . Pellet Packing Machine,Pellet Packing Equipment,Wood Pellet Pouch Packing Machine,Pellet Weighing Packing Machine Shandong Kingoro Machinery Co., Ltd , https://www.kingoromachinery.com
The company's main purification table series, air shower series, fume hood series, biological safety cabinet series are widely used in medical and health, electronics, pharmaceuticals, biology, food, agriculture, forestry, animal husbandry and veterinary, inspection and quarantine, aerospace, automotive manufacturing, Precision instruments, universities and research institutes enjoy a high reputation in the domestic and Southeast Asian markets.
Zhejiang Sujing Purifying Equipment Co., Ltd. is dedicated to serving consumers and distributors all over the world. We will provide you with the best quality products, the most humane services and the lowest price. We sincerely welcome you to join us!
Pellet size of 50 mesh, gas content is small, poor flowing feed materials, With a package of high precision, speed, less environmental pollution, advanced and reliable, high performance, easy operation.