New Product High Quality Sk Series Pneumatic Vibrator Control Box
Product Introduction:
MG series gravel pumps are designed for continuously handing the most difficult higher abrasive slurries which contain too big solids to be pumped by a common pump. The pumps are suitable for delivering slurries in mining, explosive sludge in metal melting, dredging and so on. The advantages of the pump are easy installation and operation, good performance of NPSH and abrasion resistance. Sand Suction Pump Tranfer Pump,Sand Suction Pump,Heavy Media Pump,Wear Resistant Sand Pump SHIJIAZHUANG MUYUAN INDUSTRY & TRADE CO., LTD. , https://www.cnmuyuan.com
We have the following types:
      K Series Pneumatic Ball Vibrator
      GT Series Pneumatic Gear Vibrator (also have stainless steel series)
          R Series Roller Vibrator
          SK Series Pneumatic Percussion Hammer
      FP Series Pneumatic Piston Vibrator
      NTP Series Piston reciprocating impact vibrator
      FAL Series reciprocating Piston Vibrator
      BVP Series Impact Vibrator
      FP-U Series Pipeline Vibrator
Description:
A high speed range and eccentric working moments are combined in these Vibrators to produce a powerful vibration. The body is made from an extruded stove enamelled aluminium section and the hard coated
End plates enables the vibrator to be used in the food and pharmaceutical industries. The GT-turbine vibrators comply to current international noise regulations under factory test contitions.
Design:
The vibration is produced by the centrifugalforce of the postive and negative unbalance moments in the rotor, the rotor is supported on two heavey duty, prelubricated, matched shielded ball bearings, A special
Long life grease ensures a long working life. The inner and outer raceways of the bearings are designed so that the bearings can be easily replace using only a pin-wrench. The end plates are fitted with right-andleft-hand threads and self-locking.
Vibrator control box for SKÂ Pneumatic Percussion Hammer
We have the following types:
      K Series Pneumatic Ball Vibrator
      GT Series Pneumatic Gear Vibrator (also have stainless steel series)
          R Series Roller Vibrator
          SK Series Pneumatic Percussion Hammer
      FP Series Pneumatic Piston Vibrator
      NTP Series Piston reciprocating impact vibrator
      FAL Series reciprocating Piston Vibrator
      BVP Series Impact Vibrator
      FP-U Series Pipeline Vibrator
Description:
A high speed range and eccentric working moments are combined in these Vibrators to produce a powerful vibration. The body is made from an extruded stove enamelled aluminium section and the hard coated
End plates enables the vibrator to be used in the food and pharmaceutical industries. The GT-turbine vibrators comply to current international noise regulations under factory test contitions.
Design:
The vibration is produced by the centrifugalforce of the postive and negative unbalance moments in the rotor, the rotor is supported on two heavey duty, prelubricated, matched shielded ball bearings, A special
Long life grease ensures a long working life. The inner and outer raceways of the bearings are designed so that the bearings can be easily replace using only a pin-wrench. The end plates are fitted with right-andleft-hand threads and self-locking.
MG pump is including: Sand Pump , Dredge Pump , Sand Suction Pump, Coarse Sand Pump, Pulp And Paper Gravel Pump, Sugar Beet Handling Gravel Pump.
Product Features:
-Single casing
-Wide wet-passage
-Wear resistant metal wet end part, long service life
-Discharge direction can be oriented at any degrees
-Good performance of NPSH
Application Range:
Size: 4 inch to 14 inch
Capacity: up to 4320 m3/h
Maximum head: up to 80m