No overload pump meaning
No over-load centrifugal pump is able to shut down in the head to the zero head range of any operating point of operation, are not overloaded or burnt due to overload the prime mover centrifugal pump, and at the point, the pump power reserve factor K≈ 1.0. Although air conditioning and Industrial Fans are both cooling devices, the difference is still significant. The cooling effect of air conditioning is indeed better than other cooling equipment, but a series of problems such as high cost, high energy consumption, and inconvenient installation have become greater obstacles for enterprises to install and use air conditioning. Moreover, long-term use of air conditioning is detrimental to human health, and cleaning is cumbersome. In addition, air conditioning is not very suitable for some tall space places such as factories, farms, etc. However, if you want to improve the ventilation of factory buildings, there is a lot of smoke and dust The use of air conditioning not only fails to improve the ventilation effect of the factory environment, but also increases the economic costs of enterprises due to issues such as stuffy environment. Therefore, industrial fans have emerged, which are increasingly popular and loved by people due to their advantages such as large coverage area, easy cleaning, low noise, energy conservation and environmental protection. PMSM Ceiling Fans,Gesum Ceiling Fan,High Profile Ceiling Fan,Industrial High Volume Fan Julai (Chongqing) ventilation equipment Co.,Ltd , https://www.julaifans.com
Without overload centrifugal pump can also be called full head pump, full flow pump, with generalized saturated shaft power characteristics of the centrifugal pump, the shaft power of the extreme centrifugal pumps. Can be seen that the essence of non-overload centrifugal pump, the pump shaft power curve peak or shaft power with the flow rate increases and have smaller changes, the shaft power curve is relatively flat, so that the pump shaft power in the dead head to zero Head (ie from zero flow to maximum flow) are less than or equal to the prime mover's power.
Abroad, although there was a company that produced no-load centrifugal pump as early as the beginning of this century, that is, a centrifugal pump with a saturated shaft power, no overload pump has not been widely produced and used under the environment of focusing on pump efficiency and size. In recent years, with the development of science and technology and the increasing awareness of reliability, in many applications, in order to improve the reliability of operation, people once again attach importance to this type of centrifugal pump with saturated shaft power. Matching single units should take into account the maximum power and safety margins that may be present in the pump in order to meet frequently varying or adverse operating conditions and an increase in shaft power due to efficiency over long periods of time.
China's research on no-load centrifugal pump in its infancy, there is no mature hydraulic model, there is no mature design methods and procedures