Fastener, Wedge Anchor, Anchor Bolt
Plastic Film Dewatering Drying Machine
Plastic Film Dewatering Drying Machine is used after the plastic film/plastic agricultural film/PP woven bags/Space bag/tons bags/thin waste plastics plastic sheets washed,using the squeeze dewatering principle,squeeze the water from the plastic by rotating screw.The water will flow out from the bottom,the plastic will get hot by high intensity extrusion friction,and will plasticizing mildly after the mould heating.Finally the blade will cut the granules from the mould.
Advantage of squeezer dryer plastic machine:
1. Low power consumption. Main motor power between 90kw, no need to connection drying pipe system. Compare transitional horizontal dewatering machine+drying pipe system, can save power 40-50%
2. Small land occupied
3. Low rotation speed, almost no noise.
4. Dewatering function is better, final products humidity less then 3%
5. After squeeze dry granulating machine, the material can put into granulator driectly, do not need the forced feeding machine.
6. Mechanical squeeze dewatering,compared with the original hot air drying, do not need use dewatering machine, drying system and the agglomerator machine,it can save the energy greatly.
Plastic Film Dewatering Drying Machine,dewatering plasticplastic dewater machine,dry plastic dewatering machine zhangjiagang sevenstars machinery co.,ltd , https://www.sevenstarsmachinery.com
Material :medium steel, low carbon steel
Standard: DIN/ ASTM
Finish : zinc/Mechanical Galv/ Hot Dip Galv
Size: M6-M24 ( 1/4"--1"), Length : 40mm--300mm
Does not require precise hole depth or hole cleaning out.
• Anchor can be hammered below the surface of the concrete when no longer needed.
• The one-piece clip is formed around Anchor, assuring full expansion for dependable, superior holding power. Expanding clip will not fall off or twist in the hole.
• The test values listed below were obtained using 200-250 kgs/cm² concrete (no aggregate). A safe working load should not exceed 25% sated values.