China's first-class cylinder and cylinder processing equipment came out
In Wire Electrical Discharge Machining (WEDMing), or Wire-Cut EDM, a thin single-strand metal wire is fed through the work piece, typically occurring while in a submerged tank of dielectric fluid or deionized water. This fluid helps to cool the process and flush away the cut material. The Wire EDM process uses electric current to cut conductive materials leaving a smooth surface that requires no further finishing or polishing. This process is used to cut plates and to make punches, tools, and dies from any conductive material.
EDM Wire Cutting,Wire EDM service,Wire EDM Parts,EDM Wire Cut Process Hongzhun technology Co., Limited , http://www.custommoldcomponents.com
The company's newly designed SRB2530 cylinder horizontal CNC boring roller press passed the customer (Sichuan Bangli) pre-acceptance. Bangli evaluated this equipment as China's first-class cylinder and cylinder processing equipment, which can completely replace similar imported equipment.
The machine is capable of machining Ø80mm, Ø100mm, Ø160mm, Ø180mm four-aperture workpieces, which can be achieved after processing: dimensional accuracy of IT8 or above, cylindricity of 9 and surface roughness Ra0.04-0.088μm. The processing time of workpieces with an inner diameter of Ø160mm and a length of 1500mm is no more than 3 minutes.
The equipment's boring rolling process replaces the traditional honing processing technology, and the efficiency is increased by more than ten times on the original basis. It is the development direction of Chinese cylinder processing.